ADHESIVE STICK 3DLAC 80ML

3DLAC Stick is an adhesive specially designed to secure FFF/FDM 3D printing parts throughout the entire printing process, and its formula helps prevent possible errors such as warping.

Characteristics:

• High level of fixation
• Quick drying
• Long lasting
• Works on multiple surfaces

3DLAC STICK can be applied to multiple surfaces you want to print on with 3D printers. Depending on each material, different adhesions will be obtained, so we recommend that you do some prior testing before printing with certain technical materials. When removing the parts, pay particular attention, it is advisable to wait until the temperature of the base is below 30°C and in case you do not remove the piece, let it cool in the refrigerator and the piece will release only with a light touch.

Instructions for Use

• Shake the product before use.
• On a clean, dry surface, place the container upside down and gently press the applicator against the hot bed for a few seconds and slide a small portion of product.
• Spread a thin, even layer over the print area for best results.
• Let the product dry and start printing.
• To remove the part, wait for the print base to cool and remove it.

Note:

Store in a cool, dry place, away from direct sunlight. After each use, keep the cap on.