Do you have warping problems when 3D printing? So MAGIGOO is an easy-to-use 3D printing adhesive designed to solve the problem of non-sticky first layer (warping). This is the most common problem in 3D printing for production with FFF/FDM technology.

Product Features of Magigoo Sticker:

• The pen with adhesive makes your 3D prints stick easily to the surface
• Minimizes warping
• Save time, filaments and nerves

WHAT:

Magigoo PRO adhesives are designed for professional use to work exclusively with technical filaments. These professional-grade adhesives ensure that prints stick firmly when the print bed is hot and that the part is easy to remove once cooled and that glue residue can also be easily removed.

CONTENT:

• MAGIGOO PA is designed for professional use, to work exclusively with polyamide filaments. Designed and tested to work with multiple brands of PA (nylon) and fiber-reinforced filaments.
• MAGIGOO PC is designed to work exclusively with polycarbonate-type filaments and fiber-reinforced variants.
• MAGIGOO PP is designed to work exclusively with polypropylene filaments
• MAGIGOO ABS is designed to work with a variety of filaments, including most types of PLA, ABS, HIPS, PETG and TPU filaments.
• Shake the bottle.
• Apply to the desired area by pressing the tip into the bed (activating the internal valve) and distributing as needed.
• Print according to the filament/printer manufacturer's recommendations
• Leave to cool and remove. The print should come off immediately
• Wipe clean using a damp cloth (with water) to clean.

SAFETY :

These products are for professional use. Please read the instructions carefully before use.
Using this product with filaments other than those specified may cause excessive adhesion and damage the build surface.

Some products may contain substances that are corrosive and irritating to the eyes. Wash your hands after use. Preferably use rubber gloves. Read the safety data sheets or consult the manufacturer if necessary.
The bottle applicator has a spring-loaded valve inside. To activate, press the tip firmly against the build plate. When pressing the sides of the bottle, make sure that the applicator does not come out.

SUGGESTIONS :

For larger prints a 20mm border is recommended.
In case of excessive adhesion, it is recommended to wet the print bed with a small amount of water by slowly working it under the part, this should make it easier to remove the part.