The development kit can convert the aircraft's E-Port into multiple standard hardware ports such as XT30 power output ports, USB 2.0 port and UART/PPS signal port, making it convenient for developers to connect hardware equipment and run SDK development and debugging.

1. To avoid short circuit caused by contact between the card and the aircraft arm, make sure the card is in a suitable position when used.

2. Be sure to design a heat dissipation system and metal shielding cover, if the adapter board is integrated into a load product.

3. Immediately disconnect the adapter card from the power source if you detect sparks, smoke, strange odors, or other abnormalities.

4. When using all three XT30 power ports, the total power output will be less than the aircraft's maximum power output. Be sure to develop loads within specifications on the output.

E-Port adapter card × 1

Pin connector protector × 1

E-Port coaxial cable (150mm) × 1

XT30 to USB-C Power Cable (300mm) × 1

XT30 to DC5.5 power cable (300mm) × 1

Adapter board size: 55×40×9 mm (L×W×H)

XT30 VDC output power:

DJI Mavic 3E/3T: 12-17.6V/4A

Matrix 30 series: 19.2-26.1 V/4 A

Matrix 300 RTK: 24V/4A

Matrix 350 RTK: 24V/4A

XT30 12V output power: 12V/2A

XT30 5V output power: 5V/2A

Matrix 350 RTK

Matrix 300 RTK

30/30T matrix

DJI Mavic 3E/3T